Table of Contents
Advertisement
On the Outside Wall:
1. Unscrew the outer cover and terminal
from the snorkel wall plate.
2. Engage the duct spigots with the two
ducts from the rear of the appliance. The
duct spigot on the outside of the wall
plate should be uppermost.
3. Mark the four fixing positions onto the
wall and remove the wall plate. Drill and
plug the marked positions.
4. Apply fire cement around the two duct
spigots on the inside of the wall plate
(see Figure 33).
5. Engage the duct spigots with the two
ducts from the rear of the appliance. The
duct spigot on the outside of the wall
plate should be uppermost.
Inside again:
1. Cut a cross-slot in the rubber grommet
and push it on to the gas pipe to seal the
gas inlet slot on the firebox.
2. Make
the
gas
appliance using the isolating valve as
described in the Gas Supply section.
3. Place the front and rear burner ceramics
and lay the coals, pebbles or logs as
described in the Fuel Effects Layout
Section
4. Secure the glass door as described in
the Glass Door Section.
5. If manual control option is fitted proceed
to commission the appliance.
6. For other control options proceed to
appropriate section to continue with
installation.
connection
to
the
Bead of fire
cement
Wall Plate
Figure 33
Page 25
Hide quick links:
Advertisement
Table of Contents
