Cleaning The Fuel Effect, Fire-Bed And Combustion Chamber; Cleaning Lining Board Panels; Care Of Lining Panels - Magiglo TRIBUTE PD-08-002 User, Installation & Servicing Instructions

4.1.1.
Cleaning the Fuel Effect, Fire-bed and Combustion
Chamber
1. Remove the infill plate and the glass
door panel and place it in a safe place.
2. Carefully remove all the fuel bed
ceramics from the fire. Lift out the front
and rear ceramics. Any debris/dust or
soot can be brushed off using a soft
brush.
3. Remove the two screws securing the
burner and gently lift it out of the
appliance. Clean the burner slot with a
brush and check that the venturi is
clear.
4. Check that the electrode sparks across
the gap when the ignition knob is
operated.
4.1.2.

Cleaning Lining Board Panels

Any soot or dust marks on the side, top or rear panels can be cleaned by lightly dusting them
with a very soft brush.
NOTE: Any attempt to clean the lining panels using an alternative method, will
result in irreparable damage leading to a replacement being required.
4.1.3.

Care of Lining Panels

The lining panels on this appliance must NOT be sprayed with any type of solvent-based high
temperature paint.
The very high temperatures produced within the appliance will cause the paint to bubble
and/or burn off rendering the fireback looking unsightly.
Minor surface scuffs may be treated using a water based touch up stain available at Burley fire
retailers.
Extreme care should be taken when handling and installing products containing
ceramic fibre board, so as not to cause damage.
Page 34
5. Use a vacuum cleaner to remove any
fluff or lint on the base of the
combustion chamber.
6. Refit the burner and secure in place
using the previously removed screws.
7. Replace the front and rear ceramics
and relay the fuel bed as described in
the appropriate fuel bed layout sections.
8. Refit the glass/frame and secure in
place using the previously removed
nuts. Refit the infill plate.
9. The flue can be inspected and cleaned
by removing the terminal/ outer cover.