Table of Contents
Advertisement
On the Outside Wall
1. Unscrew the outer cover and terminal
from the wall plate.
2. Engage the duct spigots with the two
ducts from the rear of the appliance. The
duct spigot on the outside of the wall
plate should be uppermost.
3. Mark the four fixing positions onto the
wall and remove the wall plate. Drill and
plug the marked positions. Do not use
Silicone to the plate.
4. Apply fire cement around the two duct
spigots on the inside of the wall plate
(see Figure 28)
5. Engage the duct spigots with the two
tubes from the rear of the appliance. The
duct spigot on the outside of the wall
plate should be uppermost. Push the
wall plate fully home and fix in position
with appropriate screws. Screw the outer
cover and terminal back onto the wall
plate. Apply a bead of mastic around the
Figure 29
Inside again
:
1. Cut a cross-slot in the rubber grommet
and push it on to the gas pipe to seal the
gas inlet slot on the firebox.
2. Make
the
gas
appliance using the isolating valve as
described in the Gas Supply section.
3. Place the front and rear burner ceramics
and lay the coals, pebbles or logs as
Page 22
connection
to
the
periphery of the wall plate to prevent
water ingress.
6. If the centre of the terminal is within 2
metres of the ground or a balcony the
terminal guard must be fitted.
7. For assembly and fitting of the terminal
guard refer to figure 16 and figure 21.
8. Fold up the four sides of the cage to 90
degrees, locking the corners with the
tabs and slots as you go. Using some
pliers from inside the cage, to fold over
the end of the locking tab at 90 degrees
to make them very tight and secure. (see
figure 29)
9. Fit the guard over the top half of the
terminal and secure to the wall using the
four fixing points. (see figure
described in the Fuel Effects Layout
Section.
4. Secure the glass door as described in
the Glass Door Section.
5. Proceed
to
depending on the control option fitted on
the appliance.
30)
Figure 30
appropriate
section
Hide quick links:
Advertisement
Table of Contents
