Table of Contents
Advertisement
3.9.7.
Fitting the Glass Panel and Frame
1. Refit the glass panel/frame and fully
secure in position using the previously
removed nuts. To ensure a good seal
tighten the nuts in a diagonal sequence a
few turns at a time
2. Fully tighten all the nuts.
3. Fit the infill plate (See Figure 48). If
required attach fret in fills with magnets
provided.
Do not fit with Harmony trim
4.
or the Accord range of trims
3.9.8.
Continuation of Installation - Remote Control
1. Unpack the box containing the Receiver and the Hand Set.
2. Fit four AA (1.5V) batteries into the receiver unit and the PP3 (9V) battery into the
transmitter (hand set).
3. Feed the cable from the receiver unit to the spade terminals on the control valve, keeping
the cable clear of the underside of the combustion chamber. The cable connectors must
be matched to the appropriately sized spade connector (see Figure 36).
4. Test the operation of the drive motor using the hand set as per Users Instructions
(Section 2.2.2 - Lighting Procedure (Remote Control) on page 6).
5. Fold the heat shield as per folding instructions supplied and position it over the receiver.
6. Proceed to Section 3.9.10 to commission the installation.
Control
Valve
Heat
Receiver
Shield
Figure 36
Figure 48
inlet
pressure
Test point
Isolating
Valve
Page 29
Hide quick links:
Advertisement
Table of Contents
