Table of Contents
Advertisement
3.9.9.
Continuation of Installation - Total Control
1. Unpack the box containing the Receiver
and the Hand Set.
2. Fit four AA (1.5V) batteries into the
receiver unit and the PP3 (9V) battery
into the transmitter (hand set).
3. Connect the cables from the valve to the
receiver as shown in Figure 37 keeping
the cables clear of the underside of the
tray. Does not force the valve cable plug
when inserting into the receiver – it only
fits one way.
4. Connect the HT lead to the receiver
5. Test the operation of the drive motor
using the hand set as per Users
Instructions (Section 2.2.3 - Lighting
Procedure (Total Control)) on page 7).
6. Fold the heat shield as per folding
instructions supplied and position it over
the receiver.
Page 30
SW
(yellow
HT
Lead
Figure 37
TC
(
)
red
)
Valve
Cable
Hide quick links:
Advertisement
Table of Contents
