Extron electronics MediaPort 200 User Manual page 78

The following items are available on the
• HDMI Input EDID — Select an EDID (resolution and refresh rate) emulation for the
HDMI input (see the Input EDID Table
EDIDs). Rotate the left
Adjust
the refresh rate. The default is
NOTE: All factory-provided EDIDs are in HDMI, LPCM-2ch format. If DVI format is
required, use a custom EDID.
• Active Pixels and Lines — (Read only) View the amount of lines and pixels that
constitute the active area of the image for the current input. On the LCD screen, active
pixels are displayed under
• Aspect Ratio — Specify how much of the display the image will fill. Rotate either
knob to select
Adjust
ratio of the input). The default is
In Fill mode, to set an aspect ratio adjustment for a single input rate, select the
•
correct size and position manually from the
Position screens
In Follow mode, each input rate is displayed with its native aspect ratio (4:3, 5:4,
•
15:9, 16:9, 16:10) with the correct letterbox or pillar box settings, visible in the
and screens of the
Position
For specific input or image raster to fill the screen in follow mode, manually set the
item on the
Position
the current output rate
NOTE: In Follow mode, the MediaPort calculates the aspect ratio at the point
the signal is applied. If the image size or position is changed via the
menu, the aspect ratio of the image may no longer match the native
Control
aspect ratio of the input signal. To resize and re-center the image, perform an
Auto-Image (see
• Auto Memory — Enables and disables Auto Memory. Auto Memories store the details
of an input signal in scaling bridge memory, so that the unit applies the appropriate
settings when it detects that signal again (see
either knob to set Auto Memory to
Adjust
• HDCP Authorized — Disable HDCP communication by causing the MediaPort input
to report to a source device as a non-authorized HDCP sink (see
the next page). Rotate either
is .
Disabled
Selecting an input EDID
To select a resolution and rate for input emulation:
1. Select
HDMI Input EDID
2. Rotate the left
Adjust
refresh rate.
3. Press or wait until the LCD screen times out to the default cycle (approximately
Next
30 seconds). The selection is saved and appears next time the
screen is accessed.
Input Configuration
on the next page for a list of the available
knob to select the resolution and the right knob to select
.
720p @ 60 Hz
and active lines, under
H
(fills the entire screen) or
Fill
.
Fill
Picture Controls
) (see Picture Control Menu
Picture Controls
menu to
Picture Controls
, .
X Y
Performing Auto-Image
Auto Memories
(the default) and
On
knob to select
Adjust
from the
Input Configuration
knob to select the resolution and the right knob to select the
MediaPort 200 • Front Panel Operation
menu:
.
V
(displays with the aspect
Follow
menu (
Size
on page 68).
menu.
, and set the to match
0 0 Size
Picture
on page 66).
on page 82). Rotate
.
Off
HDCP Authorized
or . The default
Enabled Disabled
menu.
HDMI Input EDID
and
Size
on
71