Jam Code; Jam Codes (Related To Printer Unit); Jam Codes (Related To Finisher) - Canon iR2422 series Service Manual

Chapter 13

13.3 Jam Code

13.3.1 Jam Codes (Related to Printer Unit)

Code
0104
0208
010c
0210
0214
1118

13.3.2 Jam Codes (Related to Finisher)

Code
0130
0231
0033
0035
1036
1137
13-4
Name Sensor No.
Delay jam in paper SR209
pickup section
Stationary jam in paper SR209
pickup section
Delay jam in deliver SR202,
section SR203,
SR209
Stationary jam in SR202,
delivery section SR203
Stationary jam in SR202,
machine SR203,
SR209
Door open jam SR202,
SR203,
SR209,
SW2, SW3
Name Sensor No.
Delayed feed jam PI5
Staying paper jam PI5
Stack ejection jam PI1
Staple jam Stapler HP
sensor
(built in
stapler)
Power-on jam PI5
Door open jam SW1
Description
The registration sensor cannot detect the leading edge of paper from
the moment paper pickup starts to the moment the jam detection
time is reached.
The registration sensor cannot detect the no paper status specified
time before the leading edge of the picked up paper reaches this
sensor.
- The fixing delivery sensor cannot detect presence of paper within
the specified time after turning on of the registration clutch.
- The fixing delivery sensor detected absence of paper within the
specified time after the sensor had detected presence of paper within
the specified time after turning on of the registration clutch.
- The No.1 delivery sensor cannot detect presence of paper within
the specified time after turning on of the fixing delivery sensor.
- The fixing delivery sensor cannot detect absence of paper within
the specified time after turning off of the registration clutch.
- The fixing delivery sensor cannot detect absence of paper within
the specified time after the sensor detected the leading edge of
paper.
- The No.1 delivery sensor cannot detect absence of paper within
the specified time after the sensor detected the leading edge of
paper.
Paper was detected in the paper transport path during initial
rotation, during automatic delivery, at the end of cleaning, or at
reception of an emergency stop command.
The door was opened when there was printing paper in the transport
path.
Description
The inlet sensor is not turned on within the specified time after
reception of a paper ejection signal from the host machine.
The inlet sensor is not turned off even if paper is fed by the specified
distance after the leading edge of the paper from the host machine
has passed through the sensor.
When a paper stack is ejected, the HP sensor is not turned off within
the specified time.
The stapler HP sensor was turned off once after start of stapler
operation, but the HP has not been reached within the specified
time.
The inlet sensor detected paper at power-on.
The front cover switch detected opening of the front cover during
standby or copy operation.
0020-4324
0020-4325