4)Remove the screw [1].
5) Remove the reader heater (right) [2].
- Wire saddle [3] 1 pc.
- Connector [4] 1 pc.
[2]
4.4.8.2 Removing the Reader Heater (Left) (When the
ADF is not installed)
MEMO:
Illustrations of this procedure are figured the document size sensor equipped
model, but procedure is same as document size sensors are not equipped
model.
1) Open the copyboard cover.
2) Remove the reader front cover.
3) Remove the cover [1].
- Screws [2] 5 pcs.
4) Pull the drive belt (front) [3] in the direction of the arrow to move the con-
tact sensor [4] to the center.
[3]
[1]
[2]
[4]
[3]
[1]
F-4-65
[4]
F-4-66
5) Remove the metal plate [1].
- Screws [2] 2 pcs.
[2]
0022-0966
6) Remove the heater cover [1].
- Screw [2] 1 pc.
7) Remove the reader heater (left) [1].
- Connector [2] 1 pc.
- Screw [3] 1 pc.
[3]
4.4.8.3 Removing the Reader Heater (Left) (When the
ADF is installed)
MEMO:
Illustrations of this procedure are figured the document size sensor equipped
model, but procedure is same as document size sensors are not equipped
model.
1) Open the ADF.
2) Remove the reader front cover.
3) Remove the glass retainer.
4) Remove the ADF reading glass.
[1]
F-4-67
[1]
[2]
F-4-68
[1]
[2]
F-4-69
Chapter 4
0020-4409
4-27