2.5.2 Installing the Reader Heater Harness
Before installing, make sure the host machine is turned off. If it is turned on,
go through the following:
1. Turn off the main power switch.
2. Disconnect the power cable (from the power outlet).
3. Disconnect the power cable.
[1]
1) Open the front cover [1].
[1]
[2]
[3]
F-2-62
F-2-63
2) Remove the rear cover [1].
- RS tightening screws (M3 x 8)[2], 4 pcs.
0020-4267
[2]
3) Remove the rear-left cover [2].
- RS tightening screws (M3 x 8)[1], 3 pcs.
[2]
[1]
4) Detach the copyboard cover. (If ADF is equipped, open the ADF)
5) Detach the small cover [1].
- Screw [2], 1 pc.
Chapter 2
[1]
F-2-64
[2]
[1]
F-2-65
2-27