Pressure Roller; Removing The Pressure Roller - Canon iR2422 series Service Manual

Chapter 8
9) Remove the heater harness cover [2]. Disconnect the connector [3].
- Screw [1] 1 pc.
[2]
[3]
[1]
10) Disconnect the two connectors [1], and then release the fixing unit har-
ness from the wire saddles [2].
[1]
11) Raise the delivery upper guide [1]. Remove the fixing unit [3].
- Screw [2] 3 pcs.
[2]

8.3.2 Pressure Roller

8.3.2.1 Removing the Pressure Roller

1) Remove the fixing unit.
2) Remove the fixing film unit.
8-6
F-8-10
[2]
F-8-11
[1]
[3] [2]
F-8-12
3) Raise the claw [1] of the fixing unit inlet guide, and remove the slide the
fixing unit inlet guide [2] by sliding it in the direction of the arrow.
4) Remove the pressure roller [3].
- E-ring [1] 1 pc.
- Gear [2] 1 pc.
[1]
When installing the pressure roller, bring the ground plate [4] into contact
with the roller shaft [5].
[1]
0020-4447
[2]
[1]
F-8-13
[3]
F-8-14
[3] [2]
[2]