Installing The Heater Pcb - Canon iR2422 series Service Manual

3)Release the 3 hooks [1] and then remove the lower-right cover [2].
- RS tightening screws (M3 x 8)[3], 5 pcs.
4) Remove the upper-right cover [1].
- RS tightening screw (M3 x 8)[2], 1 pc.
[3]
[2]
[3]
[1]
[2]
F-2-47
5) Remove the delivery tray [1].
- RS tightening screws (M3 x 8)[2], 2 pcs.
[1]
When detaching the derivery tray, be careful not to damage the paper
holder [3].
MEMO:
When the Finisher-U2 is connected, detach the tray unit of finisher refer to
the service manual of the Finisher-U2.
6) Using a nipper or the like, cut out the face plate [2] (used to install a heater
switch) on the lower-right cover [1].

2.4.3 Installing the Heater PCB

[3]
[2]
[1]
F-2-48
Chapter 2
[1]
[2]
0020-4265
2-21