This machine can be upgraded by downloading system software programs from the personal computer (hereafter called as the PC) in which a user support tool
(hereafter called UST) has been loaded. The optiion can be upgraded by downloading system software programs from the personal computer (hereafter called as
the PC) in which a service support tool (hereafter called SST) has been loaded.
System software programs and upgrade tools are listed in the following table:
Type
System software type
Main unit
System (main controller)
Boot (boot program)
Option
Fin_U2 (Finisher-U2)
15.2 Downloading System Software
15.2.1 Downloading System
15.2.1.1 Downloading Procedure
1) Turn on the power switch of the PC and start UST.
2) When the power switch is turned on, the Found New hardware Wizard appears. Click "Cancel".
3) Press the Additional Functions key on the control panel of this machine to enter into the user mode.
4) Press the down-arrow key to select "System Settings", and then press the OK key.
5) Press the down-arrow key to select "Update Firmware", and then press the OK key.
6) When "OK to update" appears, select "Yes" and then press the OK key.
7) When "PLEASE WAIT WAITING" appears, start the UST.
Upgrade tool
Remarks
UST
The main controller also controls the reader.
UST
Boot program is upgraded automatically at the same time with System version up.
SST+Downloader PCB
Dedicated service tool (Downloader PCB: FY9-2034)
Refer to finisher service manual about the method of version up.