8.3.4 Fixing Delivery Sensor
8.3.4.1 Removing the Fixing Delivery Sensor
1) Remove the fixing unit.
2) Remove the fixing pressure release lever [2].
- Resin ring [1] 1 pc.
When installing the fixing pressure release lever, check that the rib [3] of
the lever is inside the pressure block [4].
[4]
3) Remove the fixing unit harness [2] from the wire saddle [1].
[2]
4) Remove the fixing paper guide [2].
- Screw [1] 1 pc.
[1]
[2]
[1]
F-8-24
[3]
[1]
F-8-25
[2]
F-8-26
5) Remove the right side stay [2] and left side stay [3].
- Screws [1] 2 pcs.
0020-4449
6) Disconnect the connector [1] and release the fixing DC harness [2] from
the harness guide [3]. Unhook the claw [4] and remove the sensor holder
[5].
- Screws [6] 2 pcs.
[5]
7) Release the four sensor claws [1], and then remove the fixing delivery sen-
sor [2].
[3]
[2]
[1]
F-8-27
[1]
[2]
[6]
[4]
F-8-28
[2]
F-8-29
Chapter 8
[3]
[6]
[1]
8-9