Canon iR2422 series Service Manual page 268

Chapter 13
Display
E542
E575
E584
13-8
Detail
Main Cause/Symptom
code Code
0001 - Optional tray motor or finisher controller PCB failure
- Optional tray HP sensor failure
- Optional tray clock sensor failure
- Optional tray shift motor load failure
The optional tray was operated, but the
paper surface was not detected.
0002 - Optional tray motor or finisher controller PCB failure
- Optional tray HP sensor failure
- Optional tray clock sensor failure
- Optional tray shift motor load failure
Cannot move (to the pickup position)
within the specified time.
0003 - Optional tray motor or finisher controller PCB failure
- Optional tray HP sensor failure
- Optional tray clock sensor failure
- Optional tray shift motor load failure
- The optional tray was moved upward,
but it did not reach the HP sensor within
3000 ms.
0005 - Optional tray motor or finisher controller PCB failure
- Optional tray HP sensor failure
- Optional tray clock sensor failure
- Optional tray shift motor load failure
- The encoder clock signal was not
detected two or more times when the
optional tray was operated for 300 ms.
0000 - Stack delivery motor or finisher controller PCB failure
- Stack delivery HP sensor failure
- The stack delivery motor was driven for
2000 ms in the stack delivery direction
(HP sensor approach direction), but the
stack delivery HP sensor did not turn on.
- The stack delivery motor was driven for
2000 ms in the HP sensor escape
direction, but the stack delivery HP
sensor did not turn off.
0000 - Shutter drive motor or finisher controller PCB failure
- Shutter open detection sensor failure
- Shutter clutch failure
- The shutter open sensor did not turn on
when 1000 ms have lapsed since the
shutter unit had performed open
operation, resulting in incomplete open
operation.
- The shutter open sensor did not turn off
when 1000 ms have lapsed since the
shutter unit had performed close
operation, resulting in incomplete close
operation.
Countermeasure
- Check the connector of the optional tray HP
sensor.
- Check the connector of the optional tray clock
sensor.
- Check the connector of the optional tray shift
motor.
- Replace the optional tray HP sensor.
- Replace the optional tray clock sensor.
- Replace the optional tray shift motor.
- Replace the finisher controller PCB.
- Check the connector of the optional tray HP
sensor.
- Check the connector of the optional tray clock
sensor.
- Check the connector of the optional tray shift
motor.
- Replace the optional tray HP sensor.
- Replace the optional tray clock sensor.
- Replace the optional tray shift motor.
- Replace the finisher controller PCB.
- Check the connector of the optional tray HP
sensor.
- Check the connector of the optional tray clock
sensor.
- Check the connector of the optional tray shift
motor.
- Replace the optional tray HP sensor.
- Replace the optional tray clock sensor.
- Replace the optional tray shift motor.
- Replace the finisher controller PCB.
- Check the connector of the optional tray HP
sensor.
- Check the connector of the optional tray clock
sensor.
- Check the connector of the optional tray shift
motor.
- Replace the optional tray HP sensor.
- Replace the optional tray clock sensor.
- Replace the optional tray shift motor.
- Replace the finisher controller PCB.
- Check the connector of the stack delivery HP
sensor.
- Check the connector of the stack delivery motor.
- Check the connector of the stack delivery HP
sensor.
- Replace the stack delivery motor.
- Replace the finisher controller PCB.
- Check the connector of the shutter open sensor.
- Check the connector of the shutter clutch.
- Check the connector of the shutter motor.
- Replace the shutter open sensor.
- Replace the shutter clutch.
- Replace the shutter drive motor.
- Replace the finisher controller PCB.