Canon imageRUNNER ADVANCE 4045 Trouble Error Codes List page 82

processing error)
Error is detected during decryption.
Failure of the HDD encryption key (hardware
configuration error/initialization
E610- error/encryption key error/encryption
0501 processing error)
Error in document management information
on /FSTDEV.
Rebooting due to SRAM corruption when
executing a transmission job that secures
disconnection of the power
In the case that reboot is repeated at
E611-
recovery from power down because SRAM
0000
information is corrupted and the job
information saved on SRAM cannot be read,
the phenomenon that the communication is
repeated occurs.
E674 FAX error
E677 Print server error
Printer IPC error
E710-
Error is detected by IPC communication IC
0001
of the printer engine at power ON.
IPC communication error
E711- Occurrence of error was set for 4 times or
0001 more for 1.5 seconds to the error register of
the IPC Chip.
IPC communication error (retransmission
E711- request reception error)
0001 Communication between the host machine
and the Finisher was lost.
IPC communication error (reception timeout)
E711-
Communication between the host machine
0002
and the Finisher was lost.
IPC communication error (checksum error)
E711-
Communication between the host machine
0004
and the Finisher was lost.
82
Turn OFF and then ON the power.
Clear SRAM to erase the job that
secures disconnection of the
power.
Disconnection of cable.
Check the Cable.
1. Check the cable connection.
Check the connection between
DCON side (J462) and Finisher
Lattice side (J9043) Finisher
Cable 2. Replace the DC
Controller PCB.
1. Check the cable connection.
Check the connection between
DCON side (J462) and Finisher
Lattice side (J9043) Finisher
Cable 2. Replace the DC
Controller PCB
1. Check the cable connection.
Check the connection between
DCON side (J462) and Finisher
Lattice side (J9043) Finisher