Canon imageRUNNER ADVANCE 4045 Trouble Error Codes List page 8

E246-
System error
0002
E246-
System error
0003
E247-
System error
0001
E247-
System error
0002
E247-
System error
0003
E247-
System error
0004
EEPROM error of the CCD unit
E248-
An error has occurred at power-
0001
on.
EEPROM error of the CCD unit
E248-
An error has occurred during write
0002
operation
EEPROM error of the CCD unit
E248-
An error has occurred during read
0003
operation following write operation.
Error in Zero Cross
Zero Cross failed to be detected
E261- for 500ms or more while the relay
0000 was ON. * The same condition is
detected after the error retry is
performed.
Description
Code
Reading unit
E280- communication error
0003 Reading error after
writing.
8
Contact to the sales companies.
Contact to the sales companies.
Contact to the sales companies.
Contact to the sales companies.
Contact to the sales companies.
Contact to the sales companies.
1. Disconnect and then connect the flexible
cable(CCD unit- Reader Controller PCB
(UN4)). 2. Replace the flexible cable. 3.
Replace the CCD unit.
1. Disconnect and then connect the flexible
cable(CCD unit- Reader Controller PCB
(UN4)). 2. Replace the flexible cable. 3.
Replace the CCD unit.
1. Disconnect and then connect the flexible
cable(CCD unit- Reader Controller PCB
(UN4)). 2. Replace the flexible cable. 3.
Replace the CCD unit.
1. Check the Connectors. (J113/J202) 2.
Replace the Power supply PCB (UN1). 3.
Replace the DC Controller PCB (UN2).
1. Disconnect and then connect the flexible
cable(Reader Controller PCB (UN4)-Main Controller
PCB 2 (UN14)). 2. Disconnect and then connect the
flexible cable(CCD unit- Main Controller PCB 2
(UN14)). 3. Replace the flexible cable. 4. Replace the
Reader Controller PCB (UN4). 5. Replace the Main
Controller PCB 2 (UN14).
Remedy