Canon imageRUNNER ADVANCE 4045 Trouble Error Codes List page 20

Gripper Open/Close Motor fails to
return to HP
At initial rotation, when the Motor
E571- rotates for specified period of time
0002 and cannot return to HP, it is
detected as an error if the same
symptom occurs again after the first
retry.
Gripper Unit Move Motor fails to
move from HP
At initial rotation, when the Motor
E575- rotates for specified period of time
0001 and cannot move from HP, it is
detected as an error if the same
symptom occurs again after the first
retry.
Gripper Unit Move Motor fails to
return to HP
At initial rotation, when the Motor
E575- rotates for specified period of time
0002 and cannot return to HP, it is
detected as an error if the same
symptom occurs again after the first
retry.
Shutter home position error
The stapler does not return to the
E584-
shutter home position when the stack
0002
ejection motor has been driven for 3
seconds
Code Description
Shutter Home Position Error
The stapler does not return to
E584-
the shutter home position
8001
when the Stack Ejection Motor
has been driven for 3 seconds
20
1. Check if the Motor (M7) Connector is
physically removed. 2. Replace the Motor.
3. Check if the Gripper Arm HP Sensor
(S13) Connector is physically removed. 4.
Replace the Gripper Unit HP Sensor (S7).
1. Check if the Motor (M2) Connector is
physically removed. 2. Replace the Motor.
3. Check if the Gripper Unit HP Sensor
(S7) Connector is physically removed. 4.
Replace the Gripper Unit HP Sensor (S7)
1. Check if the Motor (M2) Connector is
physically removed. 2. Replace the Motor.
3. Check if the Gripper Unit HP Sensor
(S7) Connector is physically removed. 4.
Replace the Gripper Unit HP Sensor (S7).
1. The shutter home position sensor
(PI113) is faulty. 2. The shutter
mechanism is faulty. 3. The stack ejection
motor (M102), shutter clutch (CL101), and
stack ejection lower roller clutch (CL102)
is faulty. 4. The finisher controller PCB is
faulty.
Remedy
1. The Shutter Home Position Sensor (PI113) is
faulty. 2. The wiring between the Finisher
Controller PCB and Stack Ejection Motor, and
between the Finisher Controller PCB and
Shutter Clutch is faulty. 3. The shutter
mechanism is faulty. 4. The Stack Ejection
Motor (M102), Shutter Clutch (CL101), and
Stack Ejection Lower Roller Clutch (CL102) is
faulty. 5. The Finisher Controller PCB is faulty.