Canon imageRUNNER ADVANCE 4045 Trouble Error Codes List page 41

Fixing Cleaning Web errort
error
E005-
Turning OFF and then ON
0010
the power without clearing
the error.
Drum Motor (M1) error
E012-
Lock error of the Drum Motor
0001
(M1).
Error in Waste Toner Lock
Detection Connector
disconnection
E013-
The Waste Toner Lock
0001
Detection Switch (SW5)
detects locked state 3 times
for 200 msec at power-on.
Error in Waste Toner Feed
Screw Lock detection
The Waste Toner Lock
E013-
Detection Switch detects
0002
locked state 3 times for 200
msec while the Developing
Assembly is driven.
Fixing Motor error
E014-
Lock error of the Fixing
0001
Motor (M3).
41
Clear the error.
1. Check the connection of the Main Driver PCB
(PCB2) and the Drum Motor (M1). Motor side:
J2138, PCB side: J109 2. Check the voltage of
the Drum Motor (M1) J2151. If voltage is 0V,
check the connection of the Relay PCB J520. 3.
Replace the Drum Motor (M1). 4. Check the gear
of the Drum Drive Shaft. If the load is too much,
replace the Process Unit and the Drum Drive Unit
(Shaft). 5. Replace the Main Driver PCB (PCB2).
6. Replace the DC Controller PCB (PCB1).
Check the connection of the Waste Toner Lock
Detection Switch (SW5) and the Main Driver PCB
(PCB2). Switch side: J3050, PCB side: J103
1. Check the Waste Toner Container and the
Waste Toner Container Pipe. If toner overflowed
from the Waste Toner Container clogs the outlet
of the Waste Toner Pipe, remove the clogged
toner. After removing it, check that the screw can
be seen from the outlet of the pipe. 2. Check the
connection of the Waste Toner Lock Detection
Switch (SW5) and the Main Driver PCB (PCB2).
3. Check the connection of the Main Driver PCB
(PCB2) and the DC Controller PCB (PCB1). Main
Controller side: J3050, DC Controller side: J103 4.
Replace the Waste Toner Lock Detection Switch
(SW5). 5. Replace the Waste Toner Feed Unit. 6.
Replace the Main Driver PCB (PCB2). 7. Replace
the DC Controller PCB (PCB1). (When the error is
still displayed after replacing the Waste Toner
Feed Unit and the Main Driver PCB (PCB2).)
1. Check the gear of the Fixing Drive Unit. ->
Replace the gear. 2. Replace the Fixing Motor
(M3). 3. Check the connection drawer between
the Fixing Assembly and the host machine. 4.
Replace the Main Driver PCB (PCB2).