Canon imageRUNNER ADVANCE 4045 Trouble Error Codes List page 13

EEPROM error
E505- The checksum data for the
0002 EEPROM on the punch controller
PCB has an error.
Rear end assist home position
error
E514- The stapler does not leave the
8001 rear end assist home position
when the Rear End Assist Motor
has been driven for 3 seconds.
Rear end assist home position
error
E514- The stapler does not return to the
8002 rear end assist home position
when the Rear End Assist Motor
has been driven for 3 seconds.
Shift Motor fails to move from HP
At initial rotation, when the Motor
rotates for specified period of time
E520-
and cannot move from HP, it is
0001
detected as an error if the same
symptom occurs again after the
first retry.
Shift Motor fails to return to HP
At initial rotation, when the Motor
rotates for specified period of time
E520-
and cannot return to HP, it is
0002
detected as an error if the same
symptom occurs again after the
first retry.
Front aligning plate home position
error
The aligning plate does not leave
E530-
the aligning plate front home
8001
position sensor when the
alignment plate front motor has
been driven for 4 seconds.
Front aligning plate home position
E530- error
8002 The aligning plate does not return
to aligning plate front home
13
Replace the Punch Controller PCB.
1. The Rear End Assist Home Position
Sensor (PI109) is faulty. 2. The wiring
between the Finisher Controller PCB and
Rear End Assist Motor is faulty. 3. The end
assist mechanism is faulty. 4. The Rear End
Assist Motor (M109) is faulty. 5. The Finisher
Controller PCB is faulty.
1. The Rear End Assist Home Position
Sensor (PI109) is faulty. 2. The wiring
between the Finisher Controller PCB and
Rear End Assist Motor is faulty. 3. The end
assist mechanism is faulty. 4. The Rear End
Assist Motor (M109) is faulty. 5. The Finisher
Controller PCB is faulty
1. Check if the Motor (M4) Connector is
physically removed. 2. Check if the Motor
failure occurs. 3. Check if the Shift Roller HP
Sensor (S2) Connector is physically
removed. 4. Check if the Shift Roller HP
Sensor (S2) failure occurs.
1. Check if the Motor (M4) Connector is
physically removed. 2. Check if the Motor
failure occurs. 3. Check if the Shift Roller HP
Sensor (S2) Connector is physically
removed. 4. Check if the Shift Roller HP
Sensor (S2) failure occurs.
1. The front aligning plate home position
sensor (PI106) is faulty. 2. The wiring
between the finisher controller PCB and
front aligning plate motor is faulty. 3. The
front aligning plate is faulty. 4. The front
aligning plate motor (M103) is faulty. 5. The
finisher controller PCB is faulty.
1. The front aligning plate home position
sensor (PI106) is faulty. 2. The wiring
between the finisher controller PCB and
front aligning plate motor is faulty. 3. The