Canon imageRUNNER ADVANCE 4045 Trouble Error Codes List page 18

Code
The tray 2 shift motor speed error
E542- The lock detection signal turns OFF
8005 150 ms after the lock detection signal
turned ON.
The tray 2 shift motor acceleration
error
E542-
The lock detection signal does not
8006
turn ON when the tray 2 shift motor
has been driven for 1 second.
The tray 2 shift motor error
E542- The lock detection signal does not
8007 turn OFF when the tray 2 shift motor
is at a stop.
Front Fan lock error
While the front fan is rotating, this
machine stops the front fan after
E551-
detecting the lock signal. Then this
0001
machine retries to rotate the front
fan, but lock signal is detected again,
this machine displays the error.
Rear Fan lock error
While the rear fan is rotating, this
machine stops the front fan after
E551-
detecting the lock signal. Then this
0002
machine retries to rotate the rear fan,
but lock signal is detected again, this
machine displays the error.
Shift Roller Release Motor fails to
move from HP
E567-
0001 At initial rotation, when the Motor
rotates for specified period of time
18
Description
The finisher controller PCB is faulty.
Remedy
1. The tray 2 shift area sensor PCB is
faulty. 2. The wiring between the finisher
controller PCB and tray 2 shift motor is
faulty. 3. The tray up/down mechanism is
faulty. 4. The tray 2 shift motor (M105) is
faulty. 5. The finisher controller PCB is
faulty.
1. The tray 2 shift area sensor PCB is
faulty. 2. The wiring between the finisher
controller PCB and tray 2 shift motor is
faulty. 3. The tray up/down mechanism is
faulty. 4. The tray 2 shift motor (M105) is
faulty. 5. The finisher controller PCB is
faulty.
1. The tray 2 shift area sensor PCB is
faulty. 2. The wiring between the finisher
controller PCB and tray 2 shift motor is
faulty. 3. The tray up/down mechanism is
faulty. 4. The tray 2 shift motor (M105) is
faulty. 5. The finisher controller PCB is
faulty.
1. Check the Fan (M8). 2. Replace the
finisher controller PCB.
1. Check the Fan (M9). 2. Replace the
finisher controller PCB.
1. Check if the Motor (M5) Connector is
physically removed. 2. Check if the Motor
failure occurs. 3. Check if the Shift Roller
Release Sensor (S3) Connector is