Canon imageRUNNER ADVANCE 4045 Trouble Error Codes List page 34

E740- Network Controller error
Invalid MAC address.
0002
DDI communication error
The Reader Controller PCB detected
E743-
the communication error between the
0000
Main Controller PCB and the Reader
Controller PCB.
E744 Error in language file/BootROM
Different Image Analysis PCB model
E746
Code Description
E748 Main Controller PCB error
Download error
E753- System Software Update Error
0001 Error occurs when updating system
software of uninstalled options
E760- Main Controller PCB 2 internal error Error was detected in the Image
34
PCB 2.
1. Check the connection of the LAN
Connector. 2. Check the connection of
the Main Controller PCB 1. 3.
Replacement of the Main Controller
PCB 1.
1. Connection error between the Main
Controller PCB and the Reader
Controller PCB. 2. Failure of the
Reader Controller PCB (PCB1). 3.
Failure of the Main Controller PCB.
Download the correct version of the
language file.
1. Check the connection of the Image
Analysis PCB. 2. Replace the Image
Analysis PCB.
Replace the Main Controller PCB
Check the log to find where the download
error has been occurred. FIN_G1 Staple
Finisher-G1/Booklet Finisher-G1 IFN_D1
Inner Finisher-D1 G3CCB Super G3 FAX
Board-AK1/Super G3 2nd Line Fax Board-
AK1/Super G3 3rd/4th Line Fax Board-AK1
G3CCM Super G3 FAX Board-AK1/Super
G3 2nd Line Fax Board-AK1/Super G3
3rd/4th Line Fax Board-AK1 When any of
the above system software is displayed,
check if the target option has been
installed. When the target option has not
been installed: Turn OFF and then ON the
main power supply to restore (since there is
no system software to be updated.). When
the target option has been installed: Check
if the accessory is correctly installed and if
the target system software to be
downloaded is for the installed option. Then
download the appropriate system software
again.
Remedy