Canon imageRUNNER ADVANCE 4045 Trouble Error Codes List page 53

change, lock was unlocked for 1
second or longer. (Laser diode is
not lit up/failure of the BD
PCB/power supply error, or
condensation)
Polygon Motor BD unlock error
E100- Failed to get the Detailed Code
(communication error, power
FFFF
supply error, PCB failure, etc.).
EEPROM writing error.
E102- Failed to write to EEPROM
0001 (Power is not supplied/EEPROM
failure).
Different Laser Scanner Unit
model error
The scanner for 6075/6065/6055
E103-
models was installed to the
0001
imageRUNNER ADVANCE
8105/8095/8085 models, and vice
versa.
Polygon Motor FG unlock error
E110-
Locked state was not detected
11xx
within the specified period of time
53
Relay Harness connection to Polygon Motor
and BD PCB: J3011 3. Replace the Laser
Scanner Unit. 4. Replace the Laser Driver
PCB (PCB35). 5. Replace the DC Controller
PCB (PCB1). NOTE: When condensation
occurs inside of the machine or the Laser
Scanner Unit, this error also occurs. When
condensation occurs, leave the machine or
the unit as it is until condensation
disappears. (Use the machine or the unit in
an environment where condensation does
not occur.)
1. Check if the door is opened. Close the
door. 2. Check the connector connection,
open circuit, and the caught cable of the DC
Controller PCB (PCB1) and the Laser Driver
PCB (PCB35). DC Controller side: J471,
J472, Laser Driver side: J5100, J5101,
Relay Harness connection to Polygon Motor
(M44) and BD Sensor: J3011 3. Replace the
Laser Scanner Unit. 4. Replace the Laser
Driver PCB (PCB35). 5. Replace the DC
Controller PCB (PCB1).
1. Check if the door is opened. Close the
door. 2. Check the connector connection,
open circuit, and the caught cable of the DC
Controller PCB (PCB1) and the Laser Driver
PCB (PCB35). DC Controller side: J471,
J472, Laser Driver side: J5100, J5101,
Relay Harness connection to Polygon Motor
(M44) and BD Sensor: J3011 3. Replace the
Laser Scanner Unit. 4. Replace the Laser
Driver PCB (PCB35). 5. Replace the DC
Controller PCB (PCB1).
Replace the Laser Scanner Unit with the one
for the correct model.
1. Check if the door is opened. Close the
door. 2. Check the connector connection,
open circuit, and the caught cable of the DC