Canon imageRUNNER ADVANCE 4045 Trouble Error Codes List page 30

Code Description
Erroneous communication
with cassette pedestal
After the presence of a
E716-
cassette pedestal has
0000
been detected, the
communication fails to be
normal for 5 sec.
Communication error with
the NE Controller
Error when the NE
E717- Controller is started. The
0001 NE Controller which was
connected before turning
OFF the power is not
connected at power-on.
Communication error with
the NE Controller
E717- IPC error at NE Controller
operation. Open circuit of
0002
IPC, unable to recover the
IPC communication.
Error in coin manager
Error when the coin
manager is started. The
E719-
coin manager which was
0001
connected before turning
OFF the power is not
connected at power-on.
Error in coin manager
IPC error at coin manager
operation. Open circuit of
IPC, unable to recover the
E719-
IPC communication.
0002
When open circuit of the
pickup/delivery signal
cable is detected. Invalid
connection is detected.
Error when the Card
E719-
Reader is started
0011
The Card Reader which
30
1. Check the cable. 2. Replace the DC Controller
PCB (UN2). 3. Replace the Cassette Pedestal Driver
PCB.
Check the cable, and then go through the following to
clear the error: Service Mode > COPIER >
FUNCTION > CLEAR > ERR.
Check the cable, and then go through the following to
clear the error: Service Mode > COPIER >
FUNCTION > CLEAR > ERR.
Check the cable, and then go through the following to
clear the error: Service Mode > COPIER >
FUNCTION > CLEAR > ERR.
Check the cable, and then go through the following to
clear the error: Service Mode > COPIER >
FUNCTION > CLEAR > ERR.
Check the cable, and then go through the following to
clear the error: Service Mode > COPIER >
FUNCTION > CLEAR > ERR.
Remedy