Canon imageRUNNER ADVANCE 4045 Trouble Error Codes List page 37

Cooling Fan (FM7)
0003
When lock signal failed to be
detected for 15 sec while the Paper
Cooling Fan (FM7) is driven. * The
same condition is detected after the
error retry is performed.
Edge Shutter Home Position error
E840-
When the home position of the
0000
shutter is not detected
Code
Failure of Fixing Film Edge Cooling
Fan (Rear) (FM1)
When the lock signal is detected for 15
E840-
sec while the fixing film edge cooling
0001
fan (rear) stops. * The same status is
detected again after the retry
operation.
Rotation error of Fixing Film Edge
Cooling Fan (Rear) (FM1)
When the lock signal is detected for 15
E840-
sec while the fixing film cooling fan
0002
(rear) operates. * The same status is
detected again after the retry
operation.
Failure of Fixing Film Edge Cooling
Fan (Front) (FM2)
When the lock signal is detected for 15
E840-
sec while the fixing film edge cooling
0003
fan (front) stops. * The same status is
detected again after the retry
operation.
Rotation error of Fixing Film Edge
Cooling Fan (Front) (FM2)
When the lock signal is detected for 15
E840-
sec while the fixing film edge cooling
0004
fan (front) operates. * The same status
is detected again after the retry
operation.
37
Description
(J2209/J2509/J206). 2. Replace the Paper
Cooling Fan (FM7). 3. Replace the DC
Controller PCB (UN2).
1. Check connection of the Connectors
(J2039/J2037/J2507/ J215). 2. Replace the
fixing film edge shutter HP sensor (S10). 3.
Replace the fixing film edge shutter motor
(M8). 4. Replace the DC controller PCB
(UN2).
Remedy
1. Check connection of the Connectors
(J2036/J215). 2. Replace the fixing film
edge cooling fan (rear) (FM1) 3.
Replace the DC controller PCB (UN2).
1. Check connection of the Connectors
(J2036/J215). 2. Replace the fixing film
edge cooling fan (rear) (FM1) 3.
Replace the DC controller PCB (UN2).
1. Check connection of the Connectors
(J2035/J215). 2. Replace the fixing film
edge Cooling fan (front) (FM2) 3.
Replace the DC controller PCB (UN2).
1. Check connection of the Connectors
(J2035/J215). 2. Replace the fixing film
edge cooling fan (front) (FM2). 3.
Replace the DC controller PCB (UN2).