Canon imageRUNNER ADVANCE 4045 Trouble Error Codes List page 16

Finisher)
8001
If the tray does not return to home position
when the tray 1 shift motor is driven for 25
seconds. If the tray does not move to
other area when tray 1 shift motor is
driven for 5 seconds.
Tray 1 shift area error
The dangerous area is reached before the
E540- tray 1 paper surface sensor detects paper
8002 surface during the paper surface detection
operation. A discontinuous area is
detected during tray operation.
Swing guide switch/Staple safety switch
error
E540-
The swing guide switch or staple safety
8003
switch is activated while the tray is
operating.
The tray 1 shift motor clock error
E540- The FG input cannot be detected when
8004 the tray 1 shift motor has been driven for
0.2 second.
The tray 1 shift motor speed error
(Staple/Booklet Finisher)
E540-
The lock detection signal turns OFF 150
8005
ms after the lock detection signal turned
ON.
The tray 1 shift motor acceleration error
E540- The lock detection signal does not turn
8006 ON when the tray 1 shift motor has been
driven for 1 second.
E540- The tray 1 shift motor error
8007 The lock detection signal does not turn
16
is faulty. 2. The wiring between the
finisher controller PCB and tray 1
shift motor is faulty. 3. The tray
up/down mechanism is faulty. 4. The
tray 1 shift motor (M107) is faulty. 5.
The finisher controller PCB is faulty.
1. The tray 1 shift area sensor PCB
is faulty. 2. The wiring between the
finisher controller PCB and tray 1
shift motor is faulty. 3. The tray
up/down mechanism is faulty. 4. The
tray 1 shift motor (M107) is faulty. 5.
The finisher controller PCB is faulty.
1. The tray 1 shift area sensor PCB
is faulty. 2. The wiring between the
finisher controller PCB and tray 1
shift motor is faulty. 3. The tray
up/down mechanism is faulty. 4. The
tray 1 shift motor (M107) is faulty. 5.
The finisher controller PCB is faulty.
1. The tray 1 shift area sensor PCB
is faulty. 2. The wiring between the
finisher controller PCB and tray 1
shift motor is faulty. 3. The tray
up/down mechanism is faulty. 4. The
tray 1 shift motor (M107) is faulty. 5.
The finisher controller PCB is faulty.
1. The tray 1 shift area sensor PCB
is faulty. 2. The wiring between the
finisher controller PCB and tray 1
shift motor is faulty. 3. The tray
up/down mechanism is faulty. 4. The
tray 1 shift motor (M107) is faulty. 5.
The finisher controller PCB is faulty.
1. The tray 1 shift area sensor PCB
is faulty. 2. The wiring between the
finisher controller PCB and tray 1
shift motor is faulty. 3. The tray
up/down mechanism is faulty. 4. The
tray 1 shift motor (M107) is faulty. 5.
The finisher controller PCB is faulty.
1. The tray 1 shift area sensor PCB
is faulty. 2. The wiring between the