Canon imageRUNNER ADVANCE 4045 Trouble Error Codes List page 15

Swing home position error
The stapler does not return to the
E535-
swing home position when the
8002
swing motor has bee driven for 3
seconds.
Rear aligning plate home position
error
The aligning plate does not leave
E537-
the aligning plate rear home
8001
position sensor when the
alignment plate rear motor has
been driven for 4 seconds.
Code
Rear aligning plate home position error
The aligning plate does not return to
E537-
aligning plate rear home position sensor
8002
when the alignment plate rear motor has
been driven for 4 seconds.
Tray Lift Motor timeout error (Inner
Finisher)
Unable to complete the operation even
after the specified period of time during
E540-
initial rotation. When the Motor remains in
0001
the same area for the specified period of
time and the same symptom occurs again
after the first retry, it is detected as an
error.
Tray Lift Motor clock error (Inner Finisher)
At initial rotation, when the Tray Lift Motor
E540- rotates and clock input is not detected
within the specified period of time, it is
0005
detected as an error if the same symptom
occurs again after the first retry.
E540- Tray 1 time out error (Staple/Booklet
15
1. The swing home position sensor (PI105)
is faulty. 2. The wiring between the finisher
controller PCB and swing motor is faulty. 3.
The swing mechanism is faulty. 4. The swing
motor (M106) is faulty. 5. The finisher
controller PCB is faulty.
1. The aligning plate rear home position
sensor (PI107) is faulty. 2. The wiring
between the finisher controller PCB and
aligning plate rear motor is faulty. 3. The
rear aligning plate is faulty. 4. The rear
aligning plate motor (M104) is faulty. 5. The
finisher controller PCB is faulty.
Description Remedy
1. The aligning plate rear home
position sensor (PI107) is faulty. 2.
The wiring between the finisher
controller PCB and aligning plate
rear motor is faulty. 3. The rear
aligning plate is faulty. 4. The rear
aligning plate motor (M104) is faulty.
5. The finisher controller PCB is
faulty.
1. Check if the Motor (M11)
Connector is physically removed. 2.
Check if the Motor failure occurs. 3.
Check if the Stack Tray Clock
Sensor (S14) Connector is
physically removed. 4. Check if the
Stack Tray Clock Sensor (S14)
failure occurs.
1. Check if the Motor (M11)
Connector is physically removed. 2.
Check if the Motor failure occurs. 3.
Check if the Stack Tray Clock
Sensor (S14) Connector is
physically removed. 4. Check if the
Stack Tray Clock Sensor (S14)
failure occurs
1. The tray 1 shift area sensor PCB