Qvis I-ZEUS-HYBRID1 User Manual page 62

In the main menu, click setting, and then click Pan/Tilt Control button. The interface is shown as
in Figure 4-42. Here you can set the following items:

Channel: select the current camera channel.

Protocol: select corresponding PTZ protocol(such as PELCOD)

Address: default address is 1.

Baud rate: select corresponding baud rate. Default value is 9600.

Data bits: select corresponding data bits. Default value is 8.

Stop bits: select corresponding stop bits. Default value is 1.

Parity: there are three options: odd/even/none. Default setup is none.
After completing all the setting please click save button.
In one window display mode, right click mouse (click "Fn" Button in the front panel or click "Fn"
key in the remote control). The interface is shown as in Figure 4-43.
© Copyright Qvis ®. All documentation rights reserved.
Figure 4-42
Figure 4-43
53