Table of Contents
Advertisement
Parameter
Record
channel
Record Delay
Alarm out
Latch
Show
message
Buzzer
Alarm upload
Message
Send Email
Tour
PTZ
Activation
Video Matrix
Video Dectect: Video Loss
The video loss interface is shown as in Figure 7-42.
After analysis video, system can generate a video loss alarm when the detected moving signal
reached the sensitivity you set here.
© Copyright Qvis ®. All documentation rights reserved.
Function
Figure 7-40. There are PAL 22X18/NTSC 22X15 zones. Right
click mouse you can go to full-screen display mode. Do remember
clicking OK button to save your motion detection zone setup.
System auto activates motion detection channel(s) to record once
an alarm occurs. Please note you need to set motion detect
record period and go to Storage-> Schedule to set current
channel as schedule record.
System can delay the record for specified time after alarm ended.
The value ranges from 10s to 300s.
Enable alarm activation function. You need to select alarm output
port so that system can activate corresponding alarm device when
an alarm occurs.
System can delay the alarm output for specified time after an
alarm ended. The value ranges from 1s to 300s.
System can pop up a message to alarm you in the local host
screen if you enabled this function.
Check the box here to enable this function. The buzzer beeps
when an alarm occurs.
System can upload the alarm signal to the centre (Including alarm
centre.
When 3G network connection is OK, system can send out a
message when motion detect occurs.
If you enabled this function, System can send out an email to alert
you when an alarm occurs.
You need to check the box here to enable this function. System
begins 1-wiindow or multiple-window tour display among the
channel(s) you set to record when an alarm occurs.
Please go to chapter Error! Reference source not found. to set
tour interval and tour mode.
Here you can set PTZ movement when alarm occurs. Such as go
to preset X. See Figure 7-41.
This function is for motion detect only. Check the box here to
enable video matrix function. Right now system supports one-
channel tour function. System takes "first come and first serve"
principle to deal with the activated tour. System will process the
new tour when a new alarm occurs after previous alarm ended.
Otherwise it restores the previous output status before the alarm
activation.
152
Advertisement
Table of Contents
