Qvis I-ZEUS-HYBRID1 User Manual page 57

Note: Please note the tour setup here has higher priority than the tour setup you have set in the
Display interface. Once the two tours are both enabled, the system will enable the alarm tour when
an alarm has been triggered. If there is no alarm, system implements the tour setup in the Display
interface.

Video matrix: Once you enable this function, the selected alarm channel will be displayed in
video output channel. SPOT OUT port displays device video output. It displays video (1-window
tour) from the alarm activation channel, which you can select at the Record channel item. It has
the higher tour priority than you set in chapter Error! Reference source not found. Video
Matrix.

Buzzer: Highlight the icon to enable this function. The buzzer beeps when alarm occurs.

Alarm Status interface: This is for the digital channel. You can set the show message function
for when the IPC offline alarm or external alarm is triggered. You can see an interface shown as
in


For snapshot operation, please refer to chapter 4.4.2.
Please highlight icon
click save button, system goes back to the previous menu.
© Copyright Qvis ®. All documentation rights reserved.
Figure 4-15
to select the corresponding function. After setting all the setups please
Figure 4-34
.
48