Table of Contents
Advertisement
Network Priority
This interface is for you to set the network priority. The default setup is PPPOE>WIFI>3G>LAN. See
Figure 5-10. You can change if necessary.
Default gateway: It is to display current default gateway. This is to display if the PPPoE if PPPoE
dial has succeeded or not.
Priority: The value ranges from 0 to 3. 0 has the highest priority.
Name: It is to display network name. Use
Note: PPPoE always has the highest priority. You can change the priority of the rest three items.
Auto register
This function allows the device to auto register to the proxy you specified. In this way, you can use
the client-end to access the DVR and etc via the proxy. Here the proxy has a switch function. In the
network service, device supports the server address of IPv4 or domain.
Please follow the steps listed below to use this function.
Please set proxy server address, port, and sub-device name at the device-end. Please enable the
auto register function, the device will be able to auto register to the proxy server.
1) The setup interface is shown as in Figure 5-11.
© Copyright Qvis ®. All documentation rights reserved.
/
to move current item up/down.
Figure 5-10
91
Advertisement
Table of Contents
