Port Settings; Physical Connections; Ethernet; Protocols - Xerox WorkCentre 5022 User Manual

Environment Settings
Port Settings (Connectivity)
Item
Port
Apply button
Note Reboot the machine to enable new settings.
Ethernet (Connectivity > Physical Connections)
Item
Rated Speed
MAC Address
Apply button
Note Reboot the machine to enable new settings.
TCP/IP (Connectivity > Protocols)
IP Mode
You can set the IP operation mode. You can select from Dual Stack, IPv4, or IPv6. The Dual Stack
setting lets you use both IPv4 and IPv6 addresses. (Default: IPv4)
General
• Protocol
• Enabled is displayed.
• Physical Connection
Ethernet is displayed.
•
• Host Name
You can set the host name. You can enter between 1 and 32 single-byte alphanumeric characters or
hyphens. (Default: last 16-digit of the MAC address).
Note Hyphens (-) cannot be used as the first or last character in the string.
• IPv4
- IP Address Resolution:
You can set the method used to acquire the IP Address, Subnet Mask and Gateway Address.
You can select from STATIC, DHCP, BOOTP, RARP, or DHCP/Autonet for the address
acquisition method. (Default: DHCP/Autonet)
2-22
Description
You can activate or deactivate communication ports. You can select from
SNMP, SMB, LPD, Port9100, and Send E-mail. Activate each port by
checking its checkbox.
You can apply changes by pressing this button.
Description
You can set the Ethernet port speed. You can select from Auto, 10 Mbps
Half-Duplex, 10 Mbps Full-Duplex, 100 Mbps Half-Duplex, or 100 Mbps Full-
Duplex. (Default: Auto)
The machine's MAC address is displayed.
You can apply changes by pressing this button.
® ®
Xerox WorkCentre 5022/5024 Multifunction Printer
User Guide