Wired Network
Used to make network environment settings.
Note
This function does not display unless the Network Kit is installed.
For information on how to display the Wired Network screen, refer to
page 9-1.
Ethernet
Used to set the Ethernet type to use.
Speed
You can select Auto, 10BASE-T Half, 10BASE-T Full, 100BASE-TX Half, or 100BASE-TX Full.
Auto is set at the time of factory shipment.
MAC Address
You can select Auto, 10BASE-T Half, 10BASE-T Full, 100BASE-TX Half, or 100BASE-TX Full.
Auto is set at the time of factory shipment.
TCP/IP
Sets TCP/IP.
This setting is activated after restarting the machine.
IP Mode
Sets the TCP/IP operation mode.
IPv4 is set at the time of factory shipment.
Dual Stack
Select this setting when using the machine in an environment using both IPv4 and
IPv6.
IPv4
Select this setting when using the machine in an IPv4 environment.
IPv6
Select this setting when using the machine in an IPv6 environment.
®
®
Xerox
WorkCentre
5022/5024 Multifunction Printer
User Guide
System Settings Procedure
Tools
on
9-27