Circuit Cards - NEC UNIVERGE NEAX 2000 IPS Reference Manual

Chapter 4 Equipment List

Circuit Cards

The circuit cards used for
types. According to these card types, the mounting locations of card and port allocation of the
Time Division Switch are varied.
Common Control Cards
Main Processor (MP)
Firmware Processor (FP)
Ethernet
Power
Line/Trunk (LT) Cards
IP PAD, Line Circuit (LC), Central Office Trunk (COT), Tie Line Trunk (LDT/ODT), etc.
Application Processor (AP) Cards
SMDR/PMS/MCI/Hotel Printer Interface (AP00)
T1/E1 Digital Trunk Interface (DTI)
Common Control Cards
The following table shows the names and functions of each control card.
Equipment Function
Name Name
PN-CP24 MP
PN-CP27 MP
UNIVERGE 2000 IPS Request For Proposal (RFP) Reference Guide
NEAX
Issue 6
U
NIVERGE NEAX
Common Control Cards
MP Card for Single MP System
Provides LAN control function, system-based Device Registration Server
(DRS), built-in FP, built-in OAI, built-in SMDR, Virtual IPT, Virtual CSH, 33
MHz PCI BUS, Memory (SDRAM 64 MB, Flash ROM 16 MB), TDSW
(1024CH × 1024CH), 16-line CFT, PB sender, Clock, 2-line PLO (receiver
mode/source mode), two RS-232C ports, 2-line DAT (Recording duration:
Maximum 128 seconds), DK, 4-line PB receiver, Modem for remote
maintenance (33.6 Kbps), Music-on-Hold tone, BUS interface. BUS interface
functions as a driver/receiver of various signals, adjusts gate delay timing,
cable delay timing, monitors I/O Bus and PCM BUS.
Supports MP Program Download.
One card is required per system.
Main Processor Card for Backup CPU system
Provides LAN control function, system-based Device Registration Server
(DRS), Virtual FP, built-in OAI, built-in SMDR, Virtual IPT, Virtual CSH, 33
MHz PCI BUS, Memory (SDRAM 32 MB, Flash ROM 9 MB), TDSW (1024CH
× 1024CH), 16-line CFT, PB sender, Clock, 2-line PLO (receiver mode/source
mode), two RS-232C ports, 2-line DAT (Recording duration: Maximum 128
seconds), DK, 4-line PB receiver, Modem for remote maintenance (33.6
Kbps), Music-on-Hold tone, BUS interface. BUS interface functions as a
driver/receiver of various signals, adjusts gate delay timing, cable delay
timing, monitors I/O Bus and PCM BUS.
Two cards are required per Backup CPU system. One card for active MP
[MP0] and another card for stand by MP [MP1].
2000 IPS systems are divided into the following
Remarks
Page 4-3