NEC UNIVERGE NEAX 2000 IPS Reference Manual page 28

Chapter 1 Introduction
Number of PHYSICAL MODULAR CHASSIS
Built-in Router
DTMF Sender
DTMF Receiver
SN716 Desk Console
Attendant Terminal (Dterm ATT Position)
SMDR Interface
PMS Interface
ACD / MIS or OAI Interface
Remote PIM over IP (Number of PIM for Remote
Sites)
DID Dial Conversion
Call Forwarding-Outside Set
Authorization Code / Forced Account Code / Remote
Access to System(DISA) Code
Message Reminder Set
Name Display / Guest Name Display
Speed Calling-Station (Station Speed Dial) Set
MP built-in SMDR Call Record
Note 1: Each Modular Chassis has 8 Virtual LT Ports that can only be used to expand the PAD
channels from 24 to 32 using the 8IPLA w/24IPLA.
Note 2: The total number of trunk line and DTI channel shall be 256 or less. (Each trunk line and DTI
channels are required to assign the "Trunk Number" by system data programming and
maximum number of system parameter for "Trunk Number" is 256.)
Note 3: IPS DML only supports a maximum of 128 IP stations; IPS DML does not support built-in
SMDR. The IPS DML is a Stand Alone Only solution; Remote PIM's off the IPS DML are not
supported.
Page 1-22
IPS DM/IPS DML System Capacity Cont
Note 3
Note 3
UNIVERGE
NEAX
Capacity Per MC
1
Max. 1 card per Site
Max. 32 circuits per system
16
8
Max. 8 per system
Max. 2 Interface ports (RS232)
Max 1 interface port (IP) per system
Max. 1 Interface port (RS232)
Max 1 interface port (IP) per system
Max. 1 Interface port per system
Up to 30 (depending on network)
1000
496
3000
1024
512
10000
1024
2000 IPS Request for Proposal (RFP) Reference Guide
2
32
Issue 6