Input Option Hardware Errors - Lexmark CS310 Service Manual

Actions
Step 17
Are the other devices on the wireless network communicating properly?
Step 18
Verify that the wireless card is properly seated on the controller board.
Is the wireless card seated correctly?
Step 19
Properly reseat the wireless card.
Did this fix the problem?
Step 20
If there is an attached antenna, is the antenna damaged?
Step 21
Replace the antenna.
Did this fix the problem?
Step 22
Verify that the antenna is properly connected to the wireless card.
Is it connected correctly?
Step 23
Properly connect the antenna.
Did this fix the problem?
Step 24
Replace the wireless card.
Did this fix the problem?
Step 25
Replace the controller board. See
page 291.
Did this fix the problem?

Input option hardware errors

•
"550‑sheet and 650‑sheet trays input option symptoms" on page 140
• "Tray (x) sensor service check" on page 140
•
"Option and media size not recognized service check" on page 142
•
"Double feed and printout skewed service check" on page 144
• "Failed to load/feed from multipurpose feeder service check" on page 147
"Controller board removal" on
Diagnostic information
139
Yes No
Go to step 18. Contact the network
administrator.
Go to step 20. Go to step 19.
Problem resolved. Go to step 20.
Go to step 22. Go to step 21.
Problem resolved. Go to step 22.
Problem resolved. Go to step 24.
Problem resolved. Go to step 24.
Problem resolved. Go to step 25.
Problem resolved. Contact your next level
of support.
5027