Factory Defaults; Exit Config; Entering Invalid Engine Mode - Lexmark CS310 Service Manual

Factory Defaults

Warning—Potential Damage: This operation cannot be undone.
This setting enables a user to restore all of the device settings to either the network settings (on network models only)
or to the base device settings.
To print current menu settings:
Note: It is recommended that you first print the customer's current settings by printing a copy of the Menu Settings
pages. Customer settings are available from the Ready prompt Diagnostics Menu settings are available in the
Diagnostics Menu, and Config Menu settings are available in the Config Menu.
1
Turn the printer off, or select Exit Config Menu.
2
At the Ready prompt, select Menus and press Select.
3
Select Reports, and press Select.
4
Select Menu Settings Page, and press Select.
5
Enter the Diagnostic Menu, select Reports, Menu Settings Page, and press Select.
6
Turn the printer off, or select Exit Diags.
7
Enter Configuration Menu, select Reports, Menu Settings Page, and press Select.
To reset factory defaults:
1
Select Reports from the Config Menu, and press Select.
2
Select Factory Defaults, and press Select
3
Select Restore Base (for locally attached printers) or Restore STD NET (if you have integrated network support).
Submitting Changes... appears on the operator panel, and then the printer PORs (restarts in Ready mode).

Exit Config

Press Select to exit the Configuration Menu. The printer performs a power-on reset and returns to normal mode.

Entering invalid engine mode

This mode is used if the machine has invalid code and needs the correct code loaded. After entering this mode, the
firmware code can be updated.
For CS310
1
Turn off the printer.
2
Press and hold the Return and Left buttons simultaneously.
3
Turn on the printer.
4
Release the buttons after 10 seconds.
For CS410 and CS510
1
Turn off the printer.
2
Press and hold the 3, 4, and 6 buttons simultaneously.
Service menus
194
5027