147 Errors - Lexmark CS310 Service Manual

Action
Step 3
Remove the left cover assembly. See
page 219.
Check the cables connected to the cartridge motor assembly.
Is the cable connected properly?
Step 4
Replace the EP drive assembly. See
page 221.
Does the problem remain?

147 errors

147 error messages
Error code Description
147.xx Staging motor error
147.01 Staging motor has exceeded the ramp up table.
147.02 Staging motor has exceeded number of encoders
at minimum PWM.
147.03 Staging motor has exceeded number of encoders
at maximum PWM.
147.04 Motor encoder count did not change between
interrupts.
147.05 Staging motor has encountered a stall time out.
"Left cover assembly removal" on
"EP drive assembly removal" on
Diagnostic information
95
Yes No
Go to step 4. Reseat the cable.
Replace the controller The problem is solved.
board. See "Controller
board removal" on
page 291.
Action
Go to "Paper pick motor drive assembly service
check" on page 96.
5027