Misc Tests - Lexmark CS310 Service Manual

3
Touch Quick Test. You may need to scroll to the next page.
A two-page instruction sheet prints.
The printer prints the test page from the default paper source, however if the default source only supports
envelopes, then the page prints from Tray 1. Print on A4 or letter paper for the best results.
4
Determine which settings to change and follow the instructions on the printed sheets to determine the adjustment.
Description
Top Margin
Left Margin
Right Margin
Skew
Bow
Linearity
5
Touch (-) to decrease the value or (+) to increase the value. After the value appears, touch to save the value or Back
to cancel.
6
Reprint the Quick Test to evaluate the changes. Continue until each adjustment is correct.
7
Repeat steps 4 through 6 as needed.
8
Continue until all three colors are aligned. A separate Quick Test prints for each color.
9
Touch Back to exit the Alignment Menu

MISC TESTS

Motor Detect
This test initiates an automatic motor detection process that should be performed whenever the controller board is
replaced.
To run Motor Detect:
1
Remove the imaging unit and the waste toner bottle. See
2
Reinstall the right cover assembly.
3
Close the front door.
4
Enter Diagnostics menu.
5
Select MISC TESTS in the Diag Menu, and press Select.
6
Select Motor Detect, and press Select.
If you press Select before closing the front cover, then a message appears: Close Cover. Press Select.
Motor Detection In Progress... appears.
The motor detection process takes about 10 seconds, and stops automatically.
Detect Complete. Rebooting... appears, and the printer performs a POR (Power On Reset).
If the motor ran, the test was passed. If the motor did not run, the test failed.
Range
-128 to +127
-1200 to +1200
-1200 to +1200
‑50 to +50
‑50 to +50
Linearity has a separate Quick Test sheet and adjustment instructions.
Service menus
170
"Imaging unit (IU) removal" on page
5027
246.