Diagnostic Information; Troubleshooting Overview; Performing The Initial Troubleshooting Check - Lexmark CS310 Service Manual

Diagnostic information

•
"Troubleshooting overview" on page 33
• "Fixing print quality issues" on page 35
•
"Paper jams" on page 45
•
"Understanding printer messages" on page 71
• "Printer hardware errors" on page 80
•
"Input option hardware errors" on page 139
CAUTION—SHOCK HAZARD: Remove the power cord from the electrical outlet before you connect or
disconnect any cable or electronic card or assembly for personal safety and to prevent damage to the printer.
Disconnect any connections between the printer and PCs/peripherals.
CAUTION—POTENTIAL INJURY: The printer weight is greater than 18 kg (40 lb) and requires two or more
trained personnel to lift it safely.
CAUTION—HOT SURFACE: The inside of the printer might be hot. To reduce the risk of injury from a hot
component, allow the surface to cool before touching.

Troubleshooting overview

• "Performing the initial troubleshooting check" on page 33
•
"Power‑on Reset (POR) sequence" on page 34
•
"Using Safe Mode" on page 34

Performing the initial troubleshooting check

Before you start the troubleshooting procedures, perform the following checks:
•
With the power cord unplugged from the electrical outlet, check that the cord is free from the breakage, short
circuits, disconnected wires, or incorrect connections.
•
Make sure the printer is properly grounded. Check the power cord ground terminal.
•
Make sure the power supply line voltage is within 10% of the rated line voltage.
•
Make sure the machine is securely installed on a level surface in a well‑ventilated area.
•
Make sure the room temperature is between 16 and 32°C (60 and 90°F) and that the relative humidity is between
20 and 80%.
•
Avoid sites generating ammonia gas, high temperature, high humidity (near water faucets, kettles, humidifiers),
cold spaces, near open flames, and dusty areas.
•
Avoid sites exposed to direct sunlight.
•
Make sure the paper is the recommended paper for this printer.
•
Make a trial print with paper from a newly opened package, and check the result.
Diagnostic information
33
5027