Image Transfer Unit (Itu) Removal - Lexmark CS310 Service Manual

c
Check the position of the card at the left side of the printer. The small vertical post (E) in the endcap has to be
positioned in the hole above it, as show below.
d
Install the new cable making sure the connector to the board is locked into position.
Note: Reinstall the screw to hold the HVPS to the right side of the printer.

Image transfer unit (ITU) removal

1
Write down the number of the new ITU before installing it. You will need the 16-digit numeric value from the barcode
after the installation, and it is easier to see at this point.
2
Remove the right cover assembly. See
3
Remove the waste toner bottle. See
4
Remove the imaging unit (IU). See
"Right cover assembly removal" on page
"Waste toner bottle removal" on page
"Imaging unit (IU) removal" on page
Repair information
243
232.
250.
246.
5027