Actions
Step 1
Turn the printer off.
Remove the rear cover. See
Remove the operator panel. See
models only)" on page
256.
Is the operator panel assembly cable properly installed at JLCD2 on the
controller board and the operator panel assembly?
Step 2
Replace the UICC card with display. See
CS410 models only)" on page
Is the operator panel still blank?
For CS510 models:
"Rear cover removal" on page
"Operator panel removal (for CS410
"Operator panel removal (for
256.
Diagnostic information
Yes
Go to step 2.
290.
Replace the controller
board. See
board removal" on
page
291.
133
No
Reinstall the cable.
Problem resolved.
"Controller
5027