Print Quality Pages; Fuser Cleaning Process; Reports - Lexmark CS310 Service Manual

Print Quality Pages

The Print Quality Pages can be printed from both the Configuration Menu and the Diagnostics Menu. The Configuration
Menu is limited in information compared to the pages printed from the Diagnostics Menu.
To help isolate print quality problems, print the Print Quality Test Pages. The pages are formatted. The Printing
Quality Test Pages message appears, and then the pages print. The message remains on the operator panel
until all the pages print.
Press Select to print the pages. The Print Quality Test Pages contain several pages. The first page, which is printed in
English text only, contains a mixture of text and graphics. The information includes values of the Quality Menu settings
in Settings and printer and toner cartridge configuration information. The remaining pages contain only graphics.

Fuser Cleaning Process

Over the lifetime of the device, flecks that adhere to the fuser may transfer to printed pages. The three step fuser
cleaning process removes these flecks.
Values Description
Print Cleaning The printer prints three very high-coverage, one-sided pages. Each of these pages contain instructions
Pages and information that the process heats the fuser to a very high temperature in order to loosen the
flecks and make them sticky.
Start Cleaning Several high-coverage sheets are fed through the fuser in order to pick up and remove the flecks.
Process

Reports

The Reports setting contains the Menu Settings Page and Event Log.
Menu Settings Page
Print the menu settings pages to list the customer settings and to verify printer options are installed correctly. If is
helpful to print the customer settings before you restore the factory defaults or make major changes.
To print the menu settings:
1
Select Reports from the Config Menu, and press Select.
2
Select Menu Settings Page, and press Select.
Event Log
The Event Log lets the system support person print a limited set of the information contained in the Diagnostic Menu
version of the printed Event Log. The limited Configuration log and the full Diagnostics log printed versions show the
same operator panel messages when the print and follow the same layout guidelines.
To print the Event Log:
1
Select Reports from the Config Menu, and press Select.
2
Select Print Log, and press Select to begin printing the log.
Service menus
185
5027