CHAPTER 6 TROUBLESHOOTING
2.2 Scanner System
2.2.1 Replacing the Scanner Drive Cable
See Chapter 3 "Original Exposure System"> V. "Disassembly/Assembly">B. "Scan-
ner">5.2.2 "Scanner Drive Cable."
2.2.2 Adjusting the Position of the Scanner Mirror Base
See Chapter 3 "Original Exposure System">V. "Disassembly/Assembly">B. "Scanner
Drive Assembly">5.2.2 "Scanner Drive Cable."
2.2.3 When Replacing the Scanning Lamp
When Replacing the Standard White Plate
1) Check to make sure that the Execute/Memory lamp in the control panel is OFF, and turn
off the main power switch.
2) Disconnect the power plug from the power outlet.
3) Execute the following service modes in sequence:
1. COPIER>FUNCTION>CCD>CCD-ADJ
2. COPIER>FUNCTION>CCD-LUT-ADJ
4) Execute the following service mode to generate a service label; then, store the service
label in the service book case.
• COPIER>FUNCTION>MISC-P>LBL-PRINT
5) Turn off and then on the main power switch.
6-18
COPYRIGHT© 2001 CANON INC.
2000 2000 2000 2000
CANON iR8500 REV.0 MAR. 2001