Canon iR8500 Servise Manual page 582

FUZZY
Use it to enable/disable fuzzy control and set the environment.
Memo
Setting 0: Fuzzy control (default)
1: low humidity environment mode (current level will be lower than
standard)
2: normal humidity environment mode
3: high humidity environment mode (current level will be higher than
standard)
SCANSLCT
Use it to enable/disable the ADF original size detection mechanism.
Memo
Setting 0: OFF (default)
1: ON
OHP-TEMP
Use it to set the transparency mode control temperature.
Memo
Setting 0: 198°C (default)
1: 193°C
2: 188°C
3: 183°C
OHT-CNT
Use it to enable/disable the transparency mode potential control mecha-
nism.
Setting 0: use target value obtained by transparency mode potential control
when in transparency mode (default)
1: do not use potential control in transparency mode
CNT-W/PR
Use it to enable/disable density variation mode during printing (PDL input).
Setting 0: correct target value to enable variation of density during printing
(default)
1: do not vary density during printing
COPYRIGHT© 2001 CANON INC.
• The change affects the current level of pre-transfer, transfer, and
separation charging.
• Setting it to 1 through 3 will make it independent of the environ-
ment sensor.
When enabled, it determines the scan size based on the original size.
To ensure separation of transparency from the fixing roller, control
will be by a lower fixing temperature.
2000 2000 2000 2000 CANON iR8500 REV.0 MAR. 2001
SERVICE MODE
COPIER>OPTION
S-85