Relocating The Machine - Canon iR8500 Servise Manual

CHAPTER 4 INSTALLATION

3 Relocating the Machine

If you need to relocate the machine after installation by truck or other means of transpor-
tation, perform the following:
No.
1 Make a single copy in Direct.
2 Remove all paper from all cassettes.
3 Turn off the power switch, and disconnect the
power plug.
4 From the left cover side, fix the No. 2 mirror
base in place using the locking plate.
5 Take out the developing assembly, process unit
and toner cartridge.
6 Tape the following in place against vibration:
transfer charging assembly, fixing/feeding unit
releasing lever, lower feeding assembly.
7 Tape the following in place: front door, hopper
cover, cassettes, right door (upper/lower).
8 Place A3 copypaper on the copyboard glass, and
tape the ADF in place.
A. If you have to use stairs when moving the machine into or out of the
user's, be sure to observe the following two points:
1. Slide out the fixing/feeding unit and take out the holding tray and all
2. Do not use the grips on the pickup/delivery assembly to support the
B. Shift up the two adjusters (front) on the bottom of the machine, to make
sure that they are unlocked. They can slip out during transportation; pro-
vide measures to avoid losing them.
C. Remove the accessories (e.g., side paper deck, finisher) when moving the
machine.
4-30
Work
copy paper form the machine; move them separately from the ma-
chine. (If an ADF is installed, separate it from the machine.)
machine; hold it supporting it by its four bottom corners.
COPYRIGHT© 2001 CANON INC.
Checks
Check to make sure that
the No. 2 mirror mount
does not move.
Pack the developing
assembly separately for
transportation.
2000 2000 2000 2000 CANON iR8500 REV.0 MAR. 2001
Remarks