Stringing The Charging Wires - Canon iR8500 Servise Manual

Hide thumbs Also See for iR8500:

Table of Contents

5.9.3 Stringing the Charging Wires

In principle, all charging wires (not the

grid wire) may be strung in the same way;

the following uses the primary charging as-

sembly as an example:

1) Remove the two screws [1], and detach

the shielding plate (left, right) [2] of the

charging assembly.

To prevent deformation (slack) of the

primary charging assembly, be sure to

work separately for the left and the right

shielding plates. (Do not loosen the

screws on the left and the right shield-

ing plates.)

2) Remove the wire cleaner.

For other charging assemblies,

remove the two covers.

3) Free about a length of charging wire

(about 5 cm) from the charging wire

reel (0.06 mm in wire diameter), and

form a loop at the end (about 2 mm in

To form a loop, wind the charg-

ing wire around a hex key once,

and twist the hex key three to

CHAPTER 5 MAINTENANCE AND INSPECTION

2000 2000 2000 2000

CANON iR8500 REV.0 MAR. 2001

Charging wire