Strutting The Grid Wire Of The Primary Charging Assembly - Canon iR8500 Servise Manual

CHAPTER 5 MAINTENANCE AND INSPECTION

5.9.4 Strutting the Grid Wire of the Primary Charging Assembly

1) Check to make sure that the four screws
used to hold the front/rear block and
shielding plate are not loose. Thereafter,
hook the end of the charging wire on
the stud A; after having strung it for 41
runs, hook it on B, C, and D, and lead it
between the two washers [1]; then, give
it a half turn around the screw [2], and
fix it in place.
2) Loosen the screws [3], [4], [5], and [6],
and tighten the screw [7] to a tightening
torque of 1.5 ±0.25 kg•cm; then,
tighten the screws [3], [4], [5], and [6]
in the sequence indicated to a tightening
torque of 8 kg•cm or more.
5-58
COPYRIGHT© 2001 CANON INC.
B
C
D [1]
[2]
F05-509-08
[5]
[6]
[3]
[4]
F05-509-09
2000 2000 2000 2000 CANON iR8500 REV.0 MAR. 2001
A
[7]