ENSONIQ DP/4 Musician's Manual page 88

72
Section 4 - Algorithms
16 - NonLin Density 1
Range: 00 to 99
Density 1 controls the number of echoes.
17 - NonLin Density 2
Range: 00 to 99
Density 2 controls the number of echoes in a lower frequency range. In general to get the
smoothest sound, Density 2 is usually less than the value of Density
1.
18 - NonLin Primary Send
Range: -99 to +99
This parameter controls the level of the diffused input signal which is nearly instantaneous with
respect to the input. This signal is injected directly into the Density at the specified level.
19 - Reflection 1 Time
Non Lin 1, 3 Range: 0 to 600 ms
Non Lin 2 Range: 0 to 85 ms
This controls the amount of time it takes for the first pre-echo to be injected into the Density. Pre-
echoes are the sounds which have been reflected back from the walls or other reflective surfaces.
20 - Reflection 1 Send
Range: -99 to +99
This parameter controls the level of the first pre-echo.
21 - Reflection 2 Time
Non Lin 1, 3 Range: 0 to 600 ms
Non Lin 2 Range: 0 to 85 ms
This controls the amount of time it takes for the second pre-echo to be injected into the Density.
22 - Reflection 2 Send
Range: -99 to +99
This parameter controls the level of the second pre-echo. Experiment with both positive and
negative on all echoes to change the tonal character of the results.
23 - Left/Right Balance
Range: -99 to +99
This parameter controls the left/right stereo balance of the gated reverb signal. A setting of -99
would offer hard left, whereas a setting of +99 would offer hard right. A setting of +00 would
place the reverb in the center of the stereo spectrum.
24 - Mod1 Source
25 - Mod1 Destination
26 - Mod1 Param Range Min
27 - Mod1 Param Range Max
28 - Mod2 Source
29 - Mod2 Destination
30 - Mod2 Param Range Min
31 - Mod2 Param Range Max
See the descriptions under the Algorithm Modulators earlier in this section.
ENSONIQ DP/4 Musician's Manual