ENSONIQ DP/4 Musician's Manual page 33

Section 2 - Getting Started
Front Panel Controls (cont'd.)
10) Data Entry Knob
In Select mode, rotate the Data Entry Knob to select presets. In all other modes, the knob will
change value of the currently active parameter. Turning clockwise will increase and
counterclockwise will decrease the values.
11) Unit Buttons
The four Unit buttons (A, B, C, and D) correspond to the four separate signal processors in the
DP /4. Use these buttons to activate a particular Unit for selecting presets or editing parameters.
The yellow LED above each button will light when that Unit is active. When a Unit button is
pressed a second time, it will be bypassed (the red LED will be solidly lit). Pressing again will
reactivate that Unit.
12) Config Button
The Config button allows you to select config presets and edit config parameters (e.g. signal
routing). When Config is active, the yellow LED above the button will be lit. By pressing the
Config button a second time, you can bypass all four Units (all red LEDs lit). Pressing Config a
third time will reactivate the Units.
13) Power
The power switch turns the DP /4 on and off. When you tum the power on, the display will
show "ENSONIQ * DP /
4/
and then go to Select mode.
ENSONIQ DP/4 Musician's Manual
17