Editing Algorithm Parameters - ENSONIQ DP/4 Musician's Manual

Section 2 - Getting Started
Editing Algorithm Parameters
If you are happy with the algorithm that is in a unit but want to adjust the wet/ dry mix, the level
of that unit, reverb decay time, or any other parameter within the effect, you can do this in Edit
mode.
To modify the parameters of the algorithm in a unit:
1. Press Edit (unless you are already in Edit mode).
2 Press Unit A, H, C, or D to select that unit for editing. The active unit's yellow LED should be
lit.
3. Press the Right Arrow button once to move to parameter 01, Wet/Dry Mix. The display
shows:
Parameter Number
nl
U I
~:~lgorithM
NaMe
Mix=50 UoluMe=99
Wet/Dry Mix (flashing)
The LED display should indicate parameter 01, which is the Wet/Dry Mix, and the mix value
should be flashing (if not, press the Left or Right Arrow button until this is the case).
4. Move the Data Entry Knob to adjust the mix. A value of 00 is fully" dry" (no effect) and a
value of 99 is fully "wet" (only the effect).
5. Press the Right Arrow button once more to move to parameter 02, Unit Volume. The display
shows:
Parameter Number
~:~lgorithM
NaMe
Mix=50 UoluMe=99
Unit Volume (flashing)
6. Move the Data Entry Knob to adjust the output volume of the Unit. This parameter is used to
control the levels of the various units relative to each other in a preset.
Note: The first three parameters, #00 Algorithm Select, #01 Wet/Dry Mix, and #02
Unit Volume, will be the same for all algorithms. The remaining parameters (those
reached by continuing to scroll right past parameter #02) will vary, depending on the
algorithm.
7. To perform further edits to the effect, use the Left and Right Arrow buttons to select
parameters and the Data Entry Knob to change the value of the active (flashing) parameter.
You will find a wide assortment of parameters available for each algorithm, allowing you to
customize the DP /4's effects to your exact needs.
ENSONIQ DP/4 Musician's Manual 37